Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or
4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware
Page 9
console#show version
Image Descriptions
image1 : default image
image2 :
Images currently available on Flash
--------------------------------------------------------------------
unit image1 image2 current-active next-active
--------------------------------------------------------------------
1 4.2.1.3 5.1.9.3 image1 image1
2 5.1.9.3 4.2.1.3 image2 image2
console#boot system 1 image2
Activating image image1 ..
console#boot system 2 image1
Activating image image1 ..
console#show version
Image Descriptions
image1 : default image
image2 :
Images currently available on Flash
--------------------------------------------------------------------
unit image1 image2 current-active next-active
--------------------------------------------------------------------
1 4.2.1.3 5.1.9.3 image1 image2
2 5.1.9.3 4.2.1.3 image2 image1
console#update bootcode
Update bootcode and reset (Y/N)?y
Management switch has unsaved changes.
Are you sure you want to continue? (Y/N) y
Issuing boot code update command...
Validating boot code from image...CRC Valid.
NOTE: After upgrading the switch firmware version to 5.1.9.3, the CPLD
(Complex Programmable Logic Device) code update is required on M8024-k
and PC8024/PC8024F switches if switch is running with the older CPLD
version. CPLD update can be done only via switch serial console (not
through SSH or Telnet). The latest CPLD version available for M8024k and
PC8024/PC8024F switch is Version 6.
NOTE: Administrators upgrading PowerConnect 8024/8024F/M8024k
switches MUST use the CPLD update instructions documented in detail
below.
To Next Page
Loading...
