Dell PowerEdge 2650 - System Board Connectors


System Board Connectors
See Figure5-3 and Table5-2 for the location and description of system board connectors.
Figure 5-3. System Board Connectors

Table 5-1.SystemBoardJumperSettings
Jumper
Setting
Description
PASSWD
(default)
The password feature is enabled.
The password feature is disabled.
NVRAM_CLR
(default)
The configuration settings are retained at system boot.
The configuration settings are cleared at next system boot. (If the configuration settings become corrupted to the point where
the system will not boot, install the jumper and boot the system. Remove the jumper before restoring the configuration
information.)
SPARE
—
To store a spare, unused jumper.