14 Rack Installation Guide
4
Install the 10-32 x 0.5-inch flange-head Phillips screws in the back mounting flange’s top and bottom
holes to secure the mounting rail to the back vertical rail.
5
Repeat steps 1 through 4 for the mounting rail on the other side of the rack.
NOTE: Ensure that the mounting rails are mounted at the same vertical position on both sides of the rack.
Figure 1-6. Installing the VersaRails
1 flange-head Phillips screws 2 mounting-bracket flange 3 mounting rails
2
front of rack
3
1
To Next Page
Loading...
