Dell POWEREDGE 4300 - Page 62

4-4 Dell PowerEdge 4300 Systems Service Manual
)URQW%H]HO
)LJXUH)URQW%H]HO5HPRYDO
To remove the front bezel, follow these steps:
1. Remove the computer cover.
2. With your fingertips, gently pry loose the four tabs along the right edge of
the bezel, and disengage the three clips on the opposite edge from the
chassis (see Figure 4-2).
3. Rotate the bezel to the left to disengage it.
To replace the bezel, align the three clips on the edge of the bezel with the
slots on the chassis and press the bezel into place until the tabs on the oppo-
site edge of the bezel snap into place.
clips (3)
tabs (4)
front bezel