Dell POWEREDGE 4300 - Guide Bracket Assembly

Removing and Replacing Parts 4-37
*XLGH%UDFNHW$VVHPEO\
)LJXUH*XLGH%UDFNHW$VVHPEO\5HPRYDO
To remove the guide bracket assembly, follow these steps:
1. Remove the system board assembly.
2. Remove any terminator card, if necessary.
3. Remove any SEC cartridge and heat sink assembly, if necessary.
4. Loosen the four captive nuts that secure the guide bracket assembly to the
system board (see Figure 4-33).
5. Lift up the assembly and remove it from the four threaded posts.
guide bracket
assembly
captive nuts (4)
threaded posts (4)