Dell POWEREDGE 4300 - Page 91

Removing and Replacing Parts 4-33
7HUPLQDWRU&DUG
)LJXUH7HUPLQDWRU &DUG5HPRYDO
To remove a terminator card, follow these steps:
1. Remove the retaining clip from the guide bracket assembly.
Using the thumb and forefinger of each hand, pinch the tabs at each end of
the clip (see Figure 4-29), and then lift the clip straight up.
2. Remove the terminator card.
Hold the card by its edges, and lift the card straight up from the guide
bracket assembly.
terminator
card
guide bracket
assembly
notch
retaining clip
tabs (2)