Dell PowerEdge FC430 - Installing a Processor-And-DIMM Blank

Figure 21. Removing and installing a processor-and-DIMM blank
1. processor-and-DIMM blank 2. memory module socket (2)
Next steps
1. Install the processor.
2. Install the heat sink.
3. Install the cooling shroud.
4. If you are removing a processor permanently, install the processor-and-DIMM blank.
5. Follow the procedure listed in After working inside your system.
Related Links
Removing the cooling shroud
Installing a processor
Installing a heat sink
Installing a processor-and-DIMM blank
Installing the cooling shroud
Installing a processor-and-DIMM blank
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
68