2. Follow the procedure listed in Before working inside your system.
3. Remove the SSD(s).
4. Disconnect all connected USB devices.
5. Keep the Phillips #1 screwdriver ready.
Steps
1. Remove the four screws securing the SSD cage to the chassis.
2. Holding the SSD cage by its edges, lift it away from the sled.
Figure 25. Removing and installing an SSD cage
1. chassis 2. guide pin slot (4)
3. SSD cage 4. screw (4)
5. guide pin (4)
Next steps
1. Install the SSD cage.
2. Install the SSD(s).
3. Reconnect the USB devices.
4. Follow the procedure listed in After working inside your system.
Related Links
Removing an SSD carrier
Installing the SSD cage
75
To Next Page
Loading...
