Dell PowerEdge FX2 - Page 32

Installing and removing PowerEdge FX2/
FX2s enclosure components
This section provides information on installing and removing the enclosure components. For information on removing and
installing the sled components, see the relevant sled Owner’s Manual at Dell.com/poweredgemanuals.
Topics:
• Customer and field replaceable units—PowerEdge FX2/FX2s
• Safety instructions
• Before working inside your system
• After working inside your system
• Recommended tools
• System cover
• Sleds
• Inside the system
• CMC module
• I/O module
• PCIe module
• Expansion cards
• Power supply units
• Cooling fans
• Cooling-fan cage
• PCIe switch board
• Fan interface board
• Interposer module
• Midplane assembly
• Control panel
• KVM panel
Customer and field replaceable units—PowerEdge
FX2/FX2s
The following components are customer replaceable units (CRUs):
●
Sleds
● CMC module
● I/O module(s)
● PCIe modules
● Expansion cards
● Power supply units
● Cooling fans
The following components are field replaceable units (FRUs). Removal and installation procedures should be performed only by
Dell certified service technicians.
● Cooling-fan cage
● PCIe switch board (PowerEdge FX2s)
● Fan interface board (PowerEdge FX2)
● Interposer module(s)
● Midplane assembly
● Control panel
4
32 Installing and removing PowerEdge FX2/FX2s enclosure components