100 Installing System Components
NOTE: To avoid interference with other components, the maximum allowable
dimensions of the USB key are 24 mm (0.94") wide x 79 mm (3.11") long x 8.6 mm
(0.33") high.
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 78.
3
Locate the USB connector on the control panel board. See Figure 6-1.
4
Insert the USB memory key into the USB connector.
5
Close the system. See "Closing the System" on page 79.
6
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Figure 3-12. Removing and Installing a USB Memory Key
1 USB memory key 2 USB memory key connector
R310HOM.book Page 100 Thursday, March 4, 2010 1:03 AM
To Next Page
Loading...
