Dell PowerEdge R510 - Installing an Expansion-Card Riser

128 Installing System Components
Figure 3-21. Installing or Removing an Expansion-Card Riser
Installing an Expansion-Card Riser
1 To install an expansion-card riser, align the riser guides with the riser guide
posts on the system board. See Figure 3-21.
2 Lower the expansion-card riser into place until the expansion-card riser
connector is fully seated.
3 If applicable, reinstall the expansion card. See "Installing an Expansion
Card" on page 124.
1 integrated storage controller slot 2 riser guides (2)
3 expansion-card riser 4 expansion card slot
5 riser guide posts (2) 6 expansion-card riser slots (2)
6
1
2
3
5
4
book.book Page 128 Friday, November 20, 2009 2:56 PM