Dell PowerEdge R510 - Removing a Hard Drive from a Hard-Drive Carrier; Installing a Hard Drive into a Hard-Drive Carrier

98 Installing System Components
Removing a Hard Drive From a Hard-Drive Carrier
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 3-11.
Figure 3-11. Installing a Cabled Hard Drive Into a Hard-Drive Carrier
*Screws are supplied along with the hard drives ordered from Dell.
Installing a Hard Drive Into a Hard-Drive Carrier
1 Insert the hard drive into the hard-drive carrier with the connector end of
the drive at the back. See Figure 3-11.
2 Align the holes on the hard drive with the holes on the hard-drive carrier.
When aligned correctly, the back of the hard drive will be flush with the
back of the hard-drive carrier.
3 Attach the four screws to secure the hard drive to the hard-drive carrier.
1 hard drive 2 hard-drive carrier
3 screws (4)*
1
3
2
book.book Page 98 Friday, November 20, 2009 2:56 PM