Table 155. GPU power cable matrix (continued)
Catego
ry
Supported GPUs Type Vendor Cable Cable quantity
HL - Half Length, FH - Full Height, FL - Full Length
NOTE: Maximum of two DW GPUs with power cables or a maximum of six SW GPUs are supported in a system based
on riser configuration.
10. Install the full length expansion card riser or half height expansion card riser. See GPU kit components table for supported
GPU risers.
11. If installing SW GPU, Install the GPU air shroud filler.
12. Install the GPU air shroud top cover.
13. Install the foam on the system cover. To install the foam,
a. Place the system cover with the System Information Label (SIL) side facing up.
b. Clean the surface of the system cover and make sure it is clean before attaching the foam.
c. For easier handling, peel off a small section of the adhesive cover and align the foam with the system cover.
d. Remove rest of the adhesive cover, and install foam on the system cover.
e. Press along the length of the foam to ensure that it is firmly affixed to the system cover.
Figure 259. Installing foam on the system cover
Upgrade Kits
311
To Next Page
Loading...
