About Your System 13
Back-Panel Features and Indicators
Figure 1-2 shows the controls, indicators, and connectors located on the system's back panel.
Figure 1-2. Back-Panel Features and Indicators
Connecting External Devices
When connecting external devices to your system, follow these guidelines:
• Most devices must be connected to a specific connector and device drivers must be installed before the
device operates properly. (Device drivers are normally included with your operating system software or
with the device itself.) See the documentation that accompanied the device for specific installation
and configuration instructions.
1 voltage selection switch 2 power connector 3 NIC connector
4 USB connectors (5) 5 serial connector 6 video connector
7 I/O expansion-card slots (5)
book.book Page 13 Tuesday, August 25, 2009 1:14 PM
To Next Page
Loading...
