Dell POWEREDGE SC440 - Installing the Chassis Intrusion Switch

72 Installing System Components
Figure 3-20. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1 Align the chassis intrusion switch with the securing bracket notch. See Figure 3-20.
2 Slide the switch into the securing bracket notch.
3 Connect the switch cable to the INTRUDER connector on the system board.
4 Close the system. See "Closing the System" on page 41.
5 Reconnect the system to the electrical outlet, and turn on the system.
1 chassis intrusion switch 2 securing bracket notch 3 INTRUDER connector
1
2
3
book.book Page 72 Tuesday, August 25, 2009 1:14 PM