66 Installing System Components
3
Disconnect the fan’s power cable from the system board by depressing the locking tab. See Figure 3-17.
4
If you are removing the smaller card cage fan (see Figure 3-17):
a
Pull up on the single release tab that attaches the fan to the chassis.
b
Slide the fan toward the back panel and lift the fan out.
5
If you are removing the larger processor cooling fan (see Figure 3-17):
a
Remove the heat sink and shroud assembly. See "Removing the Processor" on page 62. Do not
remove the processor, however.
b
Press the release tab that attaches the processor cooling fan to the chassis.
c
Slide the fan toward the back panel and lift the fan out.
Figure 3-17. Removing and Installing the Cooling Fans
1 processor cooling fan 2 release tab for processor fan 3 connector for processor fan
(CPU_CAGE)
4 connector for card cage fan
(FAN_CARD_CAGE)
5 release tab for card cage fan 6 card cage fan
book.book Page 66 Tuesday, August 25, 2009 1:14 PM
To Next Page
Loading...
