EasyManua.ls Logo

Dell PowerEdge T410 - Processor Installation; Overview;Description; DIMM Types Supported; Slots;Risers

Dell PowerEdge T410
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PowerEdge T410 Technical Guidebook
33
Dell
8.4 Processor Installation
Please refer to the PowerEdge T410 owner’s manual (downloadable from www.support.dell.com) for
information on processor installation. Memory
8.5 Overview/Description
The PowerEdge T410 uses DDR3 technology. In electronic engineering, DDR3 SDRAM or double-
data-rate three synchronous dynamic random access memory is a random access memory interface
technology used for high bandwidth storage of the working data of a computer or other digital electronic
devices. DDR3 is part of the SDRAM family of technologies and is one of the many DRAM (dynamic
random access memory) implementations.
The DDR3 primarily transfers twice the data rate of DDR2 (I/O at 8× the data rate of the memory cells it
contains), thus enabling higher bus rates and higher peak rates than earlier memory technologies. In
addition, the DDR3 standard allows for chip capacities of 512 megabits to 8 gigabits, effectively
enabling a maximum memory module size of 16 gigabytes.
DDR3 memory on the PowerEdge T410 contains:
3 channels per processor
Supports registered ECC DDR3 DIMMs or Un-buffered ECC DDDR3 DIMMs.
DDR3 speeds of 800/1066/1333 supported
8 (2/1/1) DIMM sockets (64 GB Maximum capacity)
Single Rank, Dual Rank, and Quad Rank DIMMs supported
8.6 DIMM Types Supported
1 GB, DDR3 UDIMM, 1066 w/ECC
1 GB, DDR3 UDIMM, 1333 w/ECC
1 GB, DDR3 RDIMM, 1066 w/ECC
2 GB, DDR3 UDIMM, 1066 w/ECC
2 GB, DDR3 UDIMM, 1333 w/ECC
2 GB, DDR3 RDIMM, 1066 w/ECC
2 GB, DDR3 RDIMM, 1333 w/ECC
4 GB, DDR3 RDIMM, 1066 w/ECC
4 GB, DDR3 RDIMM, 1333 w/ECC
8 GB, DDR3 RDIMM, 1066 w/ECC
8.7 Slots/Risers
The PowerEdge T410 planar provides four 72-bit (240-pin) sockets for DIMM memory modules. These
modules are DDR3-800/1066/1333 registered DDR SDRAM DIMMs. The modules are configured as
72-bits wide to provide for ECC. The memory controller in the CPU performs the ECC. The PowerEdge
T410 planar supports a minimum of 1 GB upgradeable to 64 GB of RAM, using the following DIMM
sizes:
1 GB, DIMM Module
2 GB, DIMM Module
4 GB, DIMM Module
8 GB, DIMM Module

Table of Contents

Other manuals for Dell PowerEdge T410

Related product manuals