Dell poweredge VRTX - 19 Frequently Asked Questions; Racadm; Managing and Recovering a Remote System

19
Frequently Asked Questions
This section lists the frequently asked questions about the following:
• RACADM
• Managing and Recovering a Remote System
• Active Directory
• FlexAddress and FlexAddressPlus
• iKVM
RACADM
After performing a CMC reset (using the RACADM racreset subcommand), when a command is entered, the following
message is displayed:
racadm <subcommand> Transport: ERROR: (RC=-1)
What does this message mean?
Another command must be issued only after CMC completes the reset.
Using the RACADM subcommands sometimes displays one or more of the following errors:
• Local error messages — Problems such as syntax, typographical errors, and incorrect names. For example,
ERROR: <message>
Use the RACADM help subcommand to display correct syntax and usage information. For example, if you have an error
in clearing a chassis log, run the following sub-command.
racadm chassislog help clear
CMC–related error messages — Problems where the CMC is unable to perform an action. The following error message
is displayed
racadm command failed.
To view information about a chassis, type the following command.
racadm gettracelog
While using firmware RACADM, the prompt changes to a ">" and the "$" prompt is not displayed again.
If a non-matched double quotation mark (") or a non-matched single quotation (’) is used in the command, the CLI
changes to the ">" prompt and queues all commands.
To return to the $ prompt, type <Ctrl>–d.
An error message Not Found is displayed while using the $ logout and $ quit commands.
Managing and Recovering a Remote System
When accessing the CMC Web interface, a security warning stating that the host name of the SSL certificate does not
match the host name of CMC is displayed.
189