Dell poweredge VRTX - Page 78

This file is updated as follows:
#
# Object Group "cfgLanNetworking"
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.9.143
# comment, the rest of this line is ignored
cfgNicGateway=10.35.9.1
The command racadm config -f <myfile>.cfg parses the file and identifies any errors by line number. A
correct file updates the proper entries. Additionally, you can use the same getconfig command from the previous
example to confirm the update.
Use this file to download company-wide changes or to configure new systems over the network with the command,
racadm getconfig -f <myfile>.cfg.
NOTE: Anchor is a reserved word and should not be used in the .cfg file.
78