Dell poweredge VRTX - Page 99

Privilege Description
chassis user does not have the Server Administrative privilege on the
chassis.
Server Configuration Administrator:
• Set IP address
• Set gateway
• Set subnet mask
• Set first boot device
Configure Users:
• Set iDRAC root password
• iDRAC reset
Server Control Administrator:
• Power on
• Power off
• Power cycle
• Graceful shutdown
• Server Reboot
Test Alert User User can send test alert messages.
Debug Command Administrator User can execute system diagnostic commands.
Fabric A Administrator User can set and configure the Fabric A IOM.
Fabric B Administrator User can set and configure the Fabric B, which corresponds to the first
mezzanine card in the servers and is connected to the fabric B circuitry in
the shared PCIe subsystem in the main board.
Fabric C Administrator User can set and configure the Fabric C, which corresponds to the second
mezzanine card in the servers and is connected to the fabric C circuitry in
the shared PCIe subsystem in the main board.
The CMC user groups provide a series of user groups that have preassigned user privileges.
NOTE: If you select Administrator, Power User, or Guest User, and then add or remove a privilege from the pre-
defined set, the CMC Group automatically changes to Custom.
Table 11. CMC Group Privileges
User Group Privileges Granted
Administrator
• CMC Login User
• Chassis Configuration Administrator
• User Configuration Administrator
• Clear Logs Administrator
• Server Administrator
• Test Alert User
• Debug Command Administrator
99