Dell PowerEdge - Installing PERC S140 Drivers and Settings; Pre-Installation Requirements; Setting SATA Controller to RAID Mode; Setting NVMe PCIe SSDs to RAID Mode

40 Cabling Your Blade Cluster Hardware
Figure 2-8. External Network-Attached iSCSI Cluster With Embedded Ethernet
Pass-Through Modules
1 Ethernet pass-through module 5 Ethernet pass-through module
2 port 5 6 port 5
3 port 4 7 port 4
4 Internal connections
public network
5
1
2
3
6
7
storage processors
4
book.book Page 40 Monday, December 31, 2007 3:41 PM