Introduction 15
Direct-Attached Configuration Order
1
Install the supported HBAs on your cluster nodes. See "Installing
Supported Fibre Channel HBAs" on page 44.
2
Cable the cluster nodes to the storage array. See "Cabling Storage for Your
Direct-Attached Cluster" on page 24.
3
Install the required HBA drivers and firmware versions listed in the
Dell
Cluster Configuration Support Matrices
at
dell.com/ha
.
4
Install and configure the MD Storage Manager software (included with
your storage array) on your cluster nodes. See "Installing the Storage
Management Software" on page 47.
5
Using MD Storage Manager (MDSM), configure the host servers, storage
arrays, and virtual disks. See "Configuring the Shared Storage System" on
page 48.
6
Activate and configure premium features (if applicable).
SAN-Attached Configuration Order
NOTE: A SAN-attached configuration is required to use the Remote Replication
premium feature. Remote Replication is not supported in direct-attached
configurations.
1
Install the supported HBAs on your cluster nodes. See "Installing
Supported Fibre Channel HBAs" on page 44.
2
Cable the cluster nodes to the Fibre Channel switches. See "Cabling a
SAN-Attached Cluster to an MD36x0f Storage System" on page 33 and
"Remote Replication" on page 65.
3
Install the required HBA drivers and firmware versions listed in the
Dell
Cluster Configuration Support Matrices
at
dell.com/ha
.
4
Install and configure the MD Storage Manager software (included with
your storage array) on your cluster nodes. See "Installing the Storage
Management Software" on page 47.
5
Cable the storage array to the Fibre Channel switches. See "Cabling
Storage for Your SAN-Attached Cluster" on page 30.
6
Configure zoning on all Fibre Channel switches. See "Setting Up Zoning
on the Fibre Channel Switch Hardware" on page 47.
book.book Page 15 Monday, July 25, 2011 3:18 PM
To Next Page
Loading...
