18
Getting Started With Your System
Hard-drive carrier
• One single-color activity LED
• One two-color LED status indicator per
drive
Power supply/cooling fan Three LED status indicators for power supply
status, power supply/fan fault, and AC status
RAID controller module 14 single-color LEDs:
• One battery fault
• One cache active
• One controller fault
• One controller power
• One system identification
• One management Ethernet activity
• Eight FC link or fault
2 two-color LEDs:
• One SAS OUT link or fault
• One management Ethernet link speed
Switch
System identification button Located on the front control panel.
This button is used to locate a system
within a rack.
Enclosure mode switch Located on the front of the system.
This switch is not applicable to the
PowerVault MD3600f series storage array.
Password reset switch Located on the back-panel of the RAID
controller module. This switch is used to
reset the storage array password.
LED Indicators (continued)
To Next Page
Loading...
