Engineering specifications
Ethernet
Integrated Connection I219-LM/I219-V
Table 33. Integrated Connection I219-LM/I219-V
Data Rates supported 10/100/1000 Mbps
Controller Details
Controller Bus Architecture PCIe-based interface for S0 state,
SMBus for Sx low power state
Wake On LAN Wake-on-LAN and remote wake-
up support (Magic Packet and
Pattern Match)
Integrated Memory N/A
Interface/BUS PCIe x1
Data Transfer Mode (example: Bus-Master DMA) N/A
Power Consumption (full operation per data rate connection speed) 542 mW (Max.)
Power Consumption (standby operation) 1000Mb/S Idle 439mW
IEEE Standards Compliance 802.3
Hardware Certifications N/A
Boot ROM Support EEPROM (located in SPI)
Network Transfer Mode
10BASE-T (half-duplex) 10 Mb (full/half-duplex)
100BASE-TX (half-duplex) 100 Mb (full/half-duplex)
1000BASE-T (full-duplex) 1000 Mb (full-duplex)
Environmental
Operating Temperature 0° C to 85° C (32° F to 185° F)
Operating Humidity 20% to 80% (non-condensing)
Operating System Driver Support Win7 32/64 bit, Win 8.1/10 64 bit,
Linux
Manageability WOL, PXE
Management Capabilities Alerting Intel vPro support with
appropriate Intel chipset
components
This term does not connote an actual operating speed of 1 Gb per sec. For high speed transmission, connection to a Gigabit
Ethernet server and network infrastructure is required.
3
Engineering specifications 27
To Next Page
Loading...
