About this task
The following images indicate the location of the 3.5-inch hard drive assembly and provide a visual representation of the
installation procedure.
Figure 21. Installing the 3.5-inch hard drive assembly from Bay 1
Steps
1. Slide and insert the 3.5-inch hard drive assembly into the hard drive slot.
2. Route the power cable and the data cable through the routing guides on the hard drive assembly and connect the cables to
the hard drive.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
50
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
