Table 33. System setup optionsāDisplay menu
Display
Display Brightness
Brightness on battery power Sets the screen brightness when the computer is running on battery power.
Default: 50
Brightness on AC power Sets the screen brightness when the computer is running on AC power.
Default: 0
Touch Screen Enables or disables the touch screen for the OS.
NOTE: The touch screen will always work in the BIOS setup irrespective of
this setting.
Full Screen Logo Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
Direct Graphics Controller Direct
Output Mode
When enabled, all graphics output ports directly to the Graphics Processing
Unit (GPU), bypassing Intel Integrated graphics outputs for HDMI, Thunderbolt,
and mDP ports.
Default: OFF
Table 34. System setup optionsāConnection menu
Connection
Wireless Device Enable Enable or disable internal WLAN/Bluetooth devices.
By default, WLAN is selected.
By default, Bluetooth is selected.
Enable UEFI Network Stack
Enable UEFI Network Stack When enabled, UEFI networking protocols are installed and available, allowing
pre-OS and early OS networking features to use any enabled NICs. This may be
used without PXE turned on.
Default: ON
Wireless Radio Control
Control WLAN radio Enables to sense the connection of the computer to a wired network and
subsequently disable the selected wireless radios (WLAN and/or WWAN).
Upon disconnection from the wired network, the selected wireless radios are
re-enabled.
Default: OFF
Table 35. System setup optionsāPower menu
Power
Battery Configuration Enables the computer to run on battery during power usage hours. Use the
below options to prevent AC power usage between certain times of each day.
By default Adaptive is selected.
Advanced Configuration
Enable Advanced Battery Charge
Configuration
Enables Advanced Battery Charge Configuration from the beginning of the day
to a specified work period. Advanced Battery Charged maximizes battery
health while still supporting heavy use during the work day.
Default: OFF
Peak Shift Enables the computer to run on battery during peak power usage hours.
28 System setup