Table 8. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Condition
Solid green for two
seconds
Indicates that the laptop or tablet is connected.
Flashing green (on for
two seconds and off for
two seconds)
Indicates that the laptop or tablet connected is recognized.
Turns off Indicates that the laptop or tablet is unplugged.
iDRAC Quick Sync 2 indicator codes
iDRAC Quick Sync 2 module (optional) is on the front panel of your system.
Figure 8. iDRAC Quick Sync 2 indicator
Table 9. iDRAC Quick Sync 2 indicators and descriptions (continued)
iDRAC Quick Sync 2 indicator
code
Condition Corrective action
Off (default state) Indicates that the iDRAC Quick Sync 2
feature is turned off. Press the iDRAC
Quick Sync 2 button to turn on the
iDRAC Quick Sync 2 feature.
If the LED fails to turn on, reset the left
control panel flex cable and check. If the problem
persists, see the Getting help section.
Solid white Indicates that iDRAC Quick Sync 2 is
ready to communicate. Press the iDRAC
Quick Sync 2 button to turn off.
If the LED fails to turn off, restart the system.
If the problem persists, see the Getting help
section.
Blinks white rapidly Indicates data transfer activity. NA
If the problem persists, see the Getting help
section.
Blinks white slowly Indicates that firmware update is in
progress.
NA
If the indicator continues to blink indefinitely, see
the Getting help section.
Blinks white five times rapidly
and then turns off
Indicates that the iDRAC Quick Sync 2
feature is disabled.
Check if iDRAC Quick Sync 2 feature is
configured to be disabled by iDRAC.
If the problem persists, see the Getting help
section.
For more information, see Integrated Dell
Remote Access Controller User's Guide at
dell.com/idracmanuals or Dell OpenManage
Server Administrator User’s Guide at dell.com/
openmanagemanuals .
Solid amber Indicates that the system is in fail-safe
mode.
Restart the system.
If the problem persists, see the Getting help
section.
Blinking amber Indicates that the iDRAC Quick Sync 2
hardware is not responding properly.
Restart the system.
22 Disassembly and reassembly
To Next Page
Loading...
