Figure 10. System Utilities
3. Wait while the Quick Tests automatically run.
Figure 11. Quick Test
4. Once the tests have been completed, you can view the results and additional information on the Results tab, the System
Health tab, the Configuration tab, and the Event Log tab.
5. Close the Embedded System Diagnostics utility.
6. To leave the diagnostics, click Exit.
7. Click OK when prompted, and the system reboots.
Running the Embedded System Diagnostics from the Dell Lifecycle Controller
To run the embedded system diagnostics from the Dell Lifecycle Controller:
1. As the system boots, press F10.
24 Disassembly and reassembly
To Next Page
Loading...
