Dell Precision Workstation 690 - Page 118

14. Insert the riser cards into the connectors until both riser cards snap into position.

15. Connect the power cables to memory riser cards 1 and 2.

16. Replace the memory shroud. Tighten the thumbscrews until the memory shroud is well secured and will not shift when the computer is moved.

17. Replace the computer cover (see Replacing the Computer Cover).

18. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page

NOTE: If a memory-riser power cable is not plugged in, the system will not boot.
NOTICE: The memory shroud holds the (optional) memory risers in place; its thumbscrews must be sufficiently tight in order to secure the risers and to
avoid damage.
1
memory shroud
2
thumbscrews (2)
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.