Dell Precision Workstation 690 - Page 140

Alert!PowerSupplyFanFailure—

Alert!PreviousFanFailures—

Alert!PreviousThermalFailure—

Alert!PreviousShutdownDuetoThermalEvent— Ensure that nothing is blocking the airflow vents and that all the fans are properly
installed and operating correctly. Also, ensure that the processor heat-sink assembly is properly installed.

Alert!PreviousRebootWasDuetoVoltageRegulatorFailure— Contact Dell for assistance. See Contacting Dell.

Alert!SystemBatteryVoltageisLow— Replace the battery. See Replacing the Battery.

Alert!MemoryConfigurationMismatch.PleaseenterSetupforMemoryInformationdetails.—

Alert!MemoryRisersmustbeinstalledasasetoffour—

Alert!UncorrectableMemoryErrorPreviouslyDetectedinDIMM_X/Y—


Alert!Operatinginsinglechanneldebugmode.Pleasepopulatememoryinmatchedsetsfornormaloperation.—

Alert! Memory Built-inSelfTestfailsinDIMM_X/Y— See Memory Problems.

Alert!InvalidMemoryinstalled.DIMMsmusthaveFullDIMMHeatSpreaders— Ensure that you are using or have installed the full-
length heat spreaders correctly.

Attachmentfailedtorespond— See Drive Problems.

Badcommandorfilename— Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct path
name.

Bad error-correctioncode(ECC)ondiskread— See Drive Problems.

Controllerhasfailed— See Drive Problems.

Dataerror— See Drive Problems.

Decreasingavailablememory— See Lockups and Software Problems.

Diskettedrive0seekfailure— See Drive Problems.

Diskettereadfailure— See Drive Problems.

Diskettesubsystemresetfailed— Run the Dell Diagnostics. See Dell Diagnostics.

Diskettewriteprotected— Slide the write-protect notch to the open position.
