two front-panel connectors for microphone and
headphones;
two back-panel connectors for line-in and line-out/
headphones
starts embedded system setup (during start-up only)
starts the Boot Device menu (during start-up only)
launches the utility partition (if installed) during
computer start-up
green light—blinking green in sleep state; solid green
for power-on state
amber light—blinking amber indicates that an internal
power problem might exist; solid amber indicates that
a device may be malfunctioning or incorrectly installed
(see Power Problems)
Back panel: green light for 10-Mb operation; orange
light for 100-Mb operation; yellow light for a 1000-Mb
(1-Gb) operation
Front panel: displays solid green when a network
connection is present
NOTE: If an active network connection is
present, the light will remain on even if the
onboard LAN controller is disabled in system
setup. The light will only be off when the
computer is in a low-power mode.
yellow blinking light on the back panel when there is
network activity.
four lights on the front panel
AUX_PWR on the system board
750W: 2559 BTU/hour
1KW: 3412 BTU/hour
Note: Heat dissipation is calculated based upon the
power supply wattage rating.
auto-sensing power supply—90 V to 265 V at 50/60
Hz
3-V CR2032 lithium coin cell
With stand:12.8in(32.5cm)
Without stand:8.5in(21.6cm)
Approximate minimum weight
To Next Page
Loading...
