If you press any button other than the power button, the following messages will
appear depending on the selected input:
Dell SE2717H
No VGA signal from your device.
?
Press any key on the keyboard or move the mouse to wake it up.
the correct input source.
If there is no display, press the monitor button again to select
If VGA or HDMI cable is not connected, a oating dialog box as shown below
appears. The monitor will enter Power Save Mode after 4 minutes if left at this
state.
Dell SE2717H
No VGA Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
or
Dell SE2717H
No HDMI Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
See Troubleshooting for more information.
Operating your monitor │ 41
To Next Page
Loading...
