Dell Vostro 14 5410 - Network-Port Bracket; Removing the Network-Port Bracket

To Next Page

To Previous Page

Steps

1. Place the heat-sink on the system board.

2. Align the screw holes on the heat sink to the screw holes on the system board.

3. In sequential order (1>2>3>4>5>6>7) tighten the seven captive screws that secure the heat sink to the system board.

NOTE: The number of screws varies depending on the configuration ordered.

Next steps

1. Install the base cover.

2. Exit Service Mode.

3. Follow the procedure in After working inside your computer.

Network-port bracket

Removing the network-port bracket

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Enter Service Mode.

3. Remove the base cover.

Removing and installing components

Other manuals for Dell Vostro 14 5410