Steps
1. Place the system board on the palm-rest and keyboard assembly.
2. Align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x2) that secure the system board to the palm-rest and keyboard assembly.
4. Place the Type-C port-bracket on the system board.
5. Replace the two screws (M2x4) that secure the Type-C port-bracket to the system board.
6. Connect the keyboard-backlight cable to the connector on the system board and close the latch.
NOTE: This step is only applicable if you are installing a backlit keyboard on your computer.
7. Connect the keyboard cable to the connector on the system board and close the latch.
8. Connect the touchpad cable to the connector on the system board and close the latch.
9. Connect the speaker cable to the system board.
10. Connect the I/O-board cable to the connector on the system board and close the latch.
56
Removing and installing components
To Next Page
Loading...
