Steps
1. Align and place the battery cable on the battery.
2. Route the battery cable through the routing guides on the battery.
3. Connect the battery cable to the connector on the battery.
Next steps
1. Install the 3-cell battery or 4-cell battery, whichever applicable.
2. Install the base cover.
3. Follow the procedure in After working on your computer.
Memory
Removing the memory module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
About this task
The following images indicate the location of the memory module and provide a visual representation of the removal procedure.
22 Removing and installing components
To Next Page
Loading...
