Steps
1. Place the network-port bracket on the I/O board.
2. Align the screw holes on the network-port bracket to the screw holes on the I/O board.
3. Replace the two (M2x5) screws that secure the network-port bracket to the I/O board.
Next steps
1. Install the base cover.
2. Exit Service Mode.
3. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
4. Remove the network-port bracket.
About this task
The following images indicate the location of the I/O board and provide a visual representation of the removal procedure.
42 Removing and installing components
To Next Page
Loading...
