Adding and Replacing Parts 187
Replacing a WPAN Card
NOTICE: The connectors are keyed to ensure correct insertion. If you feel
resistance, check the connectors on the card and on the system board, and realign
the card.
NOTICE: To avoid damage to the WPAN card, never place cables under the card.
1
Insert the
WPAN
card connector into the system board connector labeled
"WPAN" at a 45-degree angle.
2
Press the other end of the
WPAN
card down into the securing tabs until
the card clicks into place.
3
Connect the blue antenna cable to the
WPAN
card.
4
Secure unused antenna cables in the protective mylar sleeve.
5
Replace the Mini-Card cover and tighten the captive screws.
Flash Cache Module
The Flash Cache Module (FCM) is an internal flash drive that helps
Microsoft Windows Vista™ improve the performance of your computer. If
you ordered an FCM with your computer, the card is already installed.
NOTE: Windows
®
XP does not support an FCM. You can have an FCM installed
when running Windows XP but it will have no effect on your computer’s
performance.
Removing the FCM
1
Follow the procedures in "Before You Begin" on page 161.
2
Turn the computer over and remove the Mini-Card cover.
3
Ground yourself by touching one of the metal connectors on the back of
the computer.
NOTE: If you leave the area, ground yourself again when you return to the
computer.
4
Release the FCM by pushing the metal securing brackets away from the
card until the card pops up slightly.
5
Remove the FCM.
book.book Page 187 Tuesday, September 8, 2009 2:01 PM
To Next Page
Loading...
