Dell Vostro 1520 - USB;IEEE 1394 Board; Procedure for Removing the USB;IEEE 1394 Board

Back to Contents Page
USB/IEEE 1394 Board
Dell™Vostro™1520ServiceManual
Removing the USB/IEEE 1394 Board
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery from the computer.
3. Remove the processor and memory access panel from the computer.
4. Remove the fan from the computer.
5. Remove the hard drive and mini-card access panel from the computer.
6. Remove the hard drive from the computer.
7. Remove the optical drive from the computer.
8. Remove the hinge cover from the computer.
9. Remove the keyboard from the computer.
10. Remove the display assembly from the computer.
11. Remove the palm rest from the computer.
12. Remove the screw that secures the USB/1394 connector board to the computer chassis.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.