178 Adding and Replacing Parts
3
Connect the black antenna cable with a gray stripe to the connector
labeled "aux" (black triangle) and connect the white antenna cable with a
gray stripe to the connector labeled "main" (white triangle).
4
Secure unused antenna cables in the protective mylar sleeve.
5
Replace the cover and tighten the captive screws.
Removing a WPAN Card
1
Follow the procedures in "Before You Begin" on page 153.
2
Turn the computer over.
3
Loosen the captive screws on the Mini-Card cover and remove the cover.
4
Disconnect the blue antenna cable from the
WPAN
card.
5
Release the
WPAN
card by pushing the metal securing tabs toward the
back of the computer until the card pops up slightly.
6
Lift the
WPAN card
out of its system board connector.
1 captive screws (2) 2 Mini-Card cover
1
2
To Next Page
Loading...
