1. Route the I/O panel cables into the chassis through the I/O panel opening, and guide them through the various holes
and bays.
2. Slide the I/O panel cables into the cable clip(s) (if present).
3. Replace and tighten the screw that secures the I/O panel.
4. Reconnect the cables to the system board (see System Board Components
).
5. For the Vostro 220s:
a. Replace the chassis support bracket (see Replacing the Chassis Support Bracket
).
b. Replace any hard drives in the hard drive cage (see Replacing or Adding a Hard Drive
) that you removed in step
5 of Removing the I/O Panel.
6. Follow the procedure in After Working on Your Computer
.
Back to Contents Page
To Next Page
Loading...
