Status
Quiet Boot
Enabled; Disabled (Enabled by default)
Boot Configuration
Hard Disk Boot
Priority
Used to set the device priority of hard drives. The items displayed are dynamically updated according
to the hard drives detected.
Removable Drives
Boot Priority
Used to set the device priority of removable devices such a media card readers. The items displayed
are dynamically updated according to the removable devices connected.
First Boot Device
Removable; Hard Disk; CDROM; USB-CDROM; Legacy LAN; Disabled (Removable by default)
Second Boot
Device
Removable; Hard Disk; CDROM; USB-CDROM; Legacy LAN; Disabled (Hard disk by default)
Third Boot Device
Removable; Hard Disk; CDROM; USB-CDROM; Legacy LAN; Disabled (CD-ROM by default)
Boot Menu
Security
Enabled; Disabled (Disabled by default)
Advanced Chipset Features
Init Display
First
Onboard, PCI, PCI-Express (PCI-Express by default)
Integrated Peripherals
USB Controller Enabled or Disabled (Enabled by default)
Onboard Audio
Connector
Enabled or Disabled (Enabled by default)
Onboard LAN
Connector
Enabled or Disabled (Enabled by default)
Onboard LAN Boot
ROM
Enabled or Disabled (Disabled by default)
Serial Port
OFF, COM 1, AUTO, COM 3 (AUTO by default)
Power Management Setup
ACPI Suspend Type S1(POS); S3(STR) (S3(STR) by default)
AC Recovery Power Off, Power On, Last State (Power Off by default)
Remote Wake Up Enabled; Disabled (Enabled by default)
Auto Power On Enabled; Disabled (Disabled by default)
Auto Power On Date 0
Auto Power On Time 0:00:00
Load Defaults
Load Optimal
Defaults
Resets CMOS defaults to factory install values.
Boot Sequence
This feature allows you to change the boot sequence for devices.
Option Settings
Diskette Drive — The computer attempts to boot from a floppy drive (if installed). If the floppy disk in the drive is not
bootable, if no floppy disk is in the drive, or if there is no floppy drive installed in the computer, the computer
generates an error message.
Hard Drive — The computer attempts to boot from the primary hard drive. If no operating system is on the drive, the
computer generates an error message.