Dell Vostro 2521 - Installing the Display Assembly; Removing the Display Bezel

4. Move the LVDS and camera cable aside and remove the screws that secure the display assembly to the computer
and lift the display assembly off the computer.
Installing the Display Assembly
1. Place the display assembly on the computer.
2. Tighten the screws to secure the LVDS and camera assembly to the computer.
3. Connect the wireless mini-card antennae to the connectors on the wireless mini-card.
4. Connect the display and power port cables to the system board.
5. Affix the tape that secures the display cable to the computer.
6. Install:
a) palmrest
b) keyboard
c) optical-drive assembly
d) hard-drive assembly
e) memory module
f) access panel
g) battery
7. Follow the procedures in After Working Inside Your Computer .
Removing the Display Bezel
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) battery
b) access panel
26