Dell Vostro 260 - Installing the I;O Panel

10. Remove the SD card reader from the I/O panel bracket.
Installing The I/O Panel
1. Place the SD card reader into the I/O panel bracket.
2. Route the cable through the I/O panel slot and then slide the I/O panel towards the
top of the computer.
3. Replace the screw that secures the I/O panel.
4. Place the hard drive LED button by pushing it into it's slot.
5. Push the power button into it's slot.
6. Route the three cables through the metal clips.
7. Connect the three I/O panel and FlyWire cables to the system board.
8. Replace the
cover .
9. Follow the procedures in After Working Inside Your Computer .
36