Installing the Coin-Cell Battery
1. Place the coin cell battery into its slot on the system board.
2. Press the coin cell battery downward until the release latch springs back into place and secures it.
3. Install:
a. system-board shield
b. back cover
c. stand
4. Follow the procedures in After Working Inside Your Computer.
Removing the Heatsink
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. stand
b. back cover
c. system-board shield
3. Remove the screws that secure the heatsink to the computer. Lift and remove the heatsink from the
computer.
Installing the Heatsink
1. Align the heatsink on the system board. Tighten the screws to secure it to the computer.
2. Install:
a. system-board shield
b. back cover
c. stand
3. Follow the procedures in After Working Inside Your Computer.
19
To Next Page
Loading...
