4. Remove the nano-SIM card from the nano-SIM card tray.
5. Slide the nano-SIM card tray into the slot, until it slides into position.
Inserting the nano-SIM card
Prerequisites
NOTE: WWAN support will be available at a later date.
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: These procedures for installation of the nano-SIM card are only applicable for computers that are shipped with a
WWAN module.
About this task
The following image indicates the location of the nano-SIM card tray and provides a visual representation of the installation
procedure.
Steps
1. Insert a pin into the hole of the nano-SIM card slot.
2. Push the pin inward to release the nano-SIM card tray.
3. Slide the nano-SIM card tray out of the slot in the computer.
4. Place the nano-SIM card onto the nano-SIM card tray with the metallic contact facing down.
5. Slide the nano-SIM card tray into the slot, until it slides into position.
Next steps
1. Follow the procedure in After working inside your computer.
12
Removing and installing components
To Next Page
Loading...
