Replacing Memory Module(s) 23
6
Replacing Memory Module(s)
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
1
Follow the procedures in "Before You Begin" on page 13.
2
Remove the computer cover (see "Replacing the Computer Cover" on
page 17).
3
Locate the memory modules on the system board (see "System Board
Components" on page 8).
4
Press out the securing clip at each end of the memory module connector.
5
Grasp the module and pull it upwards.
If the module is difficult to remove, gently ease the module back and forth
to remove it from the connector.
CAUTION: Do not install ECC memory modules.
6
Ensure that you install a single memory module in DIMM connector 0, the
connector closest to the processor, before you install modules in any other
connector.
1 securing clip 2 memory module connector
To Next Page
Loading...
