Dell XPS 8200 - Removing the System Board

To attach the riser extension to the riser system board:
1. Align the two metal clips on the riser extension with the two slots on the metal base of the riser system board.
2. Align the brown RISER connector on the riser extension with the pad connectors on the riser system board.
3. Gently press the two pieces together until their edges are flush.

Removing the System Board
1. Shut down the computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
3. Disconnect the power cable from your computer, and then press the power button to ground the system board.
4. Open the computer cover.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in "Safety Instructions."
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.