Display 59
Replacing the Display Panel
1
Follow the instructions in "Before You Begin" on page 9.
2
Place the display panel over the display back cover.
3
Connect the camera cable to the connector on the camera module.
4
Route the display cable through the routing guide on the hinge.
5
Route the Mini-Card antenna cables through the routing guide on the
hinge.
6
Replace the eight screws that secure the display panel to the display back
cover.
7
Replace the display bezel (see "Replacing the Display Bezel" on page 57).
1 camera cable connector 2 screws (8)
3 display 4 hinges (2)