8
“POWER LEVEL” button
Selects the power level (MIN/MAX).
Hygrometer/thermometer button
Displays, in sequence for 2 secs., the ambient humidity, with a tolerance of +/- 5% (“ ” light
flashing) and the ambient temperature, with a tolerance of +/- 1% (“°C” light flashing).
Timer button
Sets the number of appliance operating hours (maximum 24).
Increase/decrease humidity/hours
Adjusts the desired humidity level in 5% steps and sets the timer.
Display
Meaning of the codes that may be shown on the display:
1. “
- -“ Indicates that the appliance is in Standby mode.
2. “
CT” Indicates that the appliance is operating in “COMFORT” mode.
3. “
Ft” Indicates that the tank is not fitted, is full or is positioned incorrectly.
4. “
dF” Indicates that the appliance is operating at low temperature. In this mode,
ventilation cycles are alternated with dehumidification cycles to avoid the
formation of frost. For use in particularly cold environments, heating is recom-
mended so as to raise the ambient temperature even by just a few degrees.
This allows the dehumidifier to operate in conditions that improve its perfor-
mance and accelerate the dehumidification process.
5. “
Pf” Indicates that there may be a fault with the probes, or that the ambient humi-
dity is low.
6. “
FN” Indicates that the appliance is operating in ventilation mode.
The buttons
To Next Page
Loading...
