Inbuilt Wine Cabinet Safety Precautions
Page 7Page 14
WARNING
FOLLOW WARNINGS BELOW ONLY
WHEN APPLICABLE TO YOUR MODEL
Use two or more people to move and
Ÿ
install appliance. Failure to do so can
result in back or other injury.
To ensure proper ventilation for your
Ÿ
appliance, the front of the unit must be
completely unobstructed. Choose a well-
ventilated area with temperatures above
60°F (16°C) and below 90°F (32°C). This
unit must be installed in an area protected
from the element, such as wind, rain,
water spray or drips.
The appliance should not be located next
Ÿ
to ovens, grills or other sources of high
heat.
The appliance must be installed with all
Ÿ
electrical, water and drain connections in
accordance with state and local codes. A
standard electrical supply (240V AC only,
50 Hz), properly grounded in accordance
with the local codes and regulations.
Do not kink or pinch the power supply
Ÿ
cord of appliance.
The fuse (or circuit breaker) size should be
Ÿ
10 amperes.
It is important for the appliance to be
Ÿ
levelled in order to work properly. You may
need to make several adjustments to level
it.
Never allow children to operate, play with
Ÿ
or crawl inside the appliance.
Do not use solvent-based cleaning agents
Ÿ
of abrasives on the interior. These
cleaners may damage or discolour the
interior.
Do not use this apparatus for other than its
Ÿ
intended purpose of storing beverages.
Keep ventilation openings, in the
Ÿ
appliance enclosure or in the built-in
structure, clear of obstruction.
Do not use mechanical devices or other
Ÿ
means to accelerate the defrosting
process, other than those recommended
by the manufacturer.
Do not damage the refrigerant circuit.
Ÿ
Do not use electrical appliances inside
Ÿ
the food storage compartments of the
appliance, unless they are of the type
recommended by the manufacturer.
WARNING: To avoid a hazard due to
Ÿ
instability of the appliance, it must be
fixed in accordance with the instructions.
This appliance is intended to be used in
Ÿ
household and similar applications such
as:
- staff kitchen areas in shops, offices and
other working environments;
- farm houses and by clients in hotels,
motels and other residential type
environments;
- bed and breakfast type environments;
-C a t e r i n g an d si m i l a r no n -retail
applications.
This wine chiller contains flammable
Ÿ
refrigerant (R600a; Isobutane and
insulation blowing gas) observe the
following rules to prevent ignition and
explosion:
- If the wine chiller system should get
punctured , do not touch the wall outlet
and do not use open flames. Open the
window and air out the room.
Care and Cleaning
LED Light isn’t working
I
Ÿ
stops working, call your local service
centre.
Cleaning your Inbuilt Wine Cabinet
Turn off the power, unplug the appliance,
Ÿ
and remove all items including shelves
and racks.
Wash the inside surfaces with a warm
Ÿ
water and baking soda solution. The
solution should be about 2 tablespoons of
baking soda to a quart of water.
Wash the shelves with a mild detergent
Ÿ
solution.
Wring excess water out of the sponge or
Ÿ
cloth when cleaning area of the controls,
or any electrical parts.
Wash the outside cabinet with warm
Ÿ
water and mild liquid detergent. Rinse well
and wipe dry with a clean soft cloth.
Do not use steel wool or steel brush on the
Ÿ
stainless steel. These will contaminate the
stainless steel with steel particles and
rusting may occur.
Power Failure
Most power failures are corrected within a few
hours and should not affect the temperature
of your appliance if you minimise the number
of times the door is opened.
If the power is going to be off for a longer
period of time, you need to take the proper
steps to protect your contents.
f the LED light inside your Wine Cabinet
Vacation Time
Short Vacations: Leave the Wine Chiller
Ÿ
operating during vacations of less than
three weeks.
Long Vacations: If the appliance will not be
Ÿ
used for several months, remove all items
and turn off the appliance. Clean and dry
the interior thoroughly. To prevent odor
and mold growth, leave the door open
slightly: blocking it open if necessary.
Moving your Inbuilt Wine Cabinet
Remove all items.
Ÿ
Securely tape down all loose items
Ÿ
(shelves) inside your appliance.
Turn the adjustable leg up to the base to
Ÿ
avoid damage.
Tape the door shut.
Ÿ
Be sure the appliance stays secure in the
Ÿ
upright position during transportation.
Also protect outside of appliance with a
blanket, or similar item.
Energy Saving Tips
The Inbuilt Wine Cabinet should be located in
the coolest area of the room, away from heat
producing appliances, and out of the direct
sunlight.
Disposal
This wine chiller should be disposed
appropriately, take the wine chiller to a
recycling plant for flammable refrigerant and
insulation blowing gasses.
To Next Page
Loading...
Need help?
General
